Journey FWD V6-3.5L (2009)
Headlamp Bulb: Service and Repair
BULBS
HEADLAMP HIGH BEAM
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Align the headlamp bulb and base (5) with the keyed opening on the back of the front lamp unit reflector.
2. Insert the bulb into the reflector until the base is firmly seated.
3. Rotate the bulb base clockwise about 30 degrees to lock it into place.
4. Reconnect the wire harness connector to the connector receptacle integral to the headlamp bulb base.
5. Reconnect the battery negative cable.
HEADLAMP LOW BEAM
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Align the headlamp bulb and base (2) with the keyed opening on the back of the front lamp unit reflector.
2. Insert the bulb into the reflector until the base is firmly seated.
3. Rotate the bulb base clockwise about 30 degrees to lock it into place.
4. Reconnect the wire harness connector to the connector receptacle integral to the headlamp bulb base.
5. Reconnect the battery negative cable.
POSITION LAMP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The following procedure applies only to vehicles manufactured for certain export markets. Vehicles manufactured for domestic
markets do not have a position lamp bulb, socket or wiring provided in the front lamp unit.
1. Align the base of the bulb with the position lamp bulb socket (3).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the front lamp unit housing.
4. Insert the socket and bulb straight into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the wire harness connector to the connector receptacle integral to the position lamp bulb socket.
7. Reconnect the battery negative cable.
