Lancer Shelby L4-135 2.2L SOHC Turbo (1989)
Ignition Lock: Service and Repair
W/Tilt Column
Fig. 3 Ignition Lock Cylinder Removal
Disable airbag, refer to Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair. After prodedure has been
completed, rearm airbag system.
1.
Disconnect battery ground cable.
2.
Remove turn signal switch, refer to Vehicle Lighting/Turn Signals/Turn Signal Switch/Service and Repair.
3.
Remove ignition key lamp.
4.
Position ignition lock cylinder in Lock position, then remove ignition key.
5.
Insert a thin screwdriver into lock cylinder release slot and depress spring latch which releases lock cylinder, then grasp lock cylinder and remove
from column.
6.
Reverse procedure to install.