Magnum V6-2.7L VIN R (2005)
Technical Service Bulletin # D29
Date: 040701
Campaign - PCM Reprogram for Throttle Control
July 2004
Dealer Service Instructions for:
Customer Satisfaction Notification D29
Reprogram PCM - Electronic Throttle Control
Models
2005
(LX)
Chrysler 300 and Dodge Magnum
NOTE
This notification applies only to the above vehicles equipped with a 2.7L engine (Sales Code EER) built through May 11, 2004 (MDH 051115).
IMPORTANT:
Some of the involved vehicles may be in dealer vehicle inventory. Dealers should complete this repair on these vehicles before retail delivery.
Dealers should also perform this repair on vehicles in for service. Involved vehicles can be determined by using the VIP inquiry process.
Subject
The Powertrain Control Module (PCM) software on about 3,500 of the above vehicles may cause an intermittent loss of throttle control. If this occurs,
the vehicle's engine speed will be held at a relatively low level.
Repair
The PCM must be reprogrammed (flashed) with updated software.
Parts Information
Due to the likelihood that the required labels are already in your parts inventory, no labels will be distributed initially. The following label may be
ordered as needed.
Special Tools
These existing special tools may be required to perform this repair:
Completion Reporting and Reimbursement
Claims for vehicles that have been serviced must be submitted on the DealerCONNECT Claim Entry Screen located on the Service tab. Claims