Magnum V6-2.7L VIN T (2007)
14. Remove lower timing chain cover to oil pan bolts (1).
CAUTION: Assure removal of the four lower timing cover bolts, as damage to the timing cover and/or oil pan may occur.
15. Remove oil pan and gasket.
Installation
INSTALLATION
1. Clean oil pan and sealing surfaces. Inspect timing chain cover gaskets. Replace as necessary.
2. Apply an 1/8 inch bead of Mopar(R) Engine RTV GEN II to the front T-joints (1) (oil pan gasket to timing cover gasket interface) and the rear
T-joints (2) (oil pan gasket to crankshaft rear oil seal retainer gasket interface).
3. Install oil pan gasket to block.
NOTE: To prevent oil leaks at oil pan to timing chain cover, the following tightening sequence procedure must be performed.
