Magnum V6-2.7L VIN T (2007)
8. Clip right front brake tube (3) to routing clip on bracket below Fuse And Relay Center.
9. Clip brake tubes to two routing clips (1) along upper radiator support.
CAUTION: Before installing the ABM harness connector (2) on the ABM (1), be sure the seal is properly installed in the connector.
10. Insert ABM harness connector (2) into socket of ABM (1) and close cover, locking connector in place.
11. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
12. Perform Diagnostic Verification Test and clear any faults.
