Magnum V6-2.7L VIN T (2007)
6. Using a suitable jumper wire, connect the voltmeter to measure between the battery positive cable terminal clamp and the starter solenoid B(+)
terminal stud. Rotate and hold the ignition switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten
the battery positive cable eyelet terminal connection at the starter solenoid B(+) terminal stud. Repeat the test. If the reading is still above 0.2 volt,
perform STEP 7 and STEP 8.
7. Remove the right front wheelhouse splash shield to gain access to the battery positive cable bulkhead outside terminal. Connect the voltmeter to
measure between the battery positive cable bulkhead outside terminal and the starter solenoid B(+) terminal stud. Rotate and hold the ignition
switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the battery positive cable bulkhead outside
terminal connection. Repeat the test. If the reading is still above 0.2 volt, replace the battery front positive cable.
8. Remove the right front carpet to gain access to the battery positive cable bulkhead inside terminal. Connect the voltmeter to measure between the