Magnum V6-2.7L VIN T (2007)
12. Loosen nut (5) attaching ball joint stud to lower control arm (4). Back nut off until nut is even with end of stud. Keeping nut on at this location
will help keep end of stud from distorting while using Puller in next step.
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
13. Using Puller (1), Special Tool 9360, separate ball joint stud (2) from lower control arm.
14. Remove nut (5) from end of ball joint stud attaching lower control arm to knuckle.
15. Pry knuckle downward and slide ball joint stud out of lower control arm. Position knuckle outward, away from lower control arm.
16. Slide lower control arm out of engine cradle and remove from vehicle.
Installation
INSTALLATION