Magnum V6-3.5L VIN V (2006)
Antenna Control Module: Service and Repair
Sedan
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove C-pillar upper trim.
3. Disconnect wire harness connectors and antenna cable.
4. Remove mounting fasteners and antenna module.
INSTALLATION
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected.
1. Position module into place.
2. Install and tighten mounting fasteners.
3. Connect wire harness connectors and antenna cable to antenna module.
4. Install C-pillar upper trim.
5. Connect battery negative cable.