Magnum V6-3.5L VIN V (2006)
17. Remove steering gear upper mounting bolt (4) and nut.
18. Remove steering gear lower mounting bolts (2 and 3).
19. Remove steering gear (1) and support from the exhaust system.
20. Loosen nut (4) attaching lower control arm ball joint stud to knuckle (3). Back nut off until nut is even with end of stud. Keeping nut on at this
location will help keep end of stud from distorting while using Puller in next step.
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.