Magnum V6-3.5L VIN V (2006)
5. Position the seat belt (4) and turning loop to the height adjuster on the upper B-pillar (2). Be certain that the webbing is not twisted.
6. Install and tighten the screw (1) that secures the turning loop to the seat belt height adjuster on the upper B-pillar. Tighten the screw to 40 N.m (30
ft.lbs.).
7. Position the trim cover (3) over the seat belt turning loop on the inside of the upper B-pillar.
8. Using hand pressure, press the trim cover and turning loop together until the cover snaps into place.
9. Reinstall the lower trim onto the inside of the B-pillar.
C-Pillar Trim
C-PILLAR TRIM
REMOVAL
UPPER - SEDAN
1. Remove the rear seat cushion from the vehicle.
2. Remove the lower trim from the inside of the C-pillar. Refer to Trim Panel.
3. Remove the screw that secures the outboard rear seat belt lower anchor to the quarter inner panel.
4. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the upper edge of the upper C-pillar trim (3) away from the quarter inner
panel (1) far enough to disengage the upper spring clip retainers that secure the trim to the slots in the quarter inner panel and (if equipped) the
curtain airbag support.
5. Rotate the upper edge of the upper C-pillar trim downward to disengage the locator pin (2) on the back of the panel from the locator hole in the
quarter inner panel.
6. Pull the outboard rear seat belt webbing and lower anchor through the slot in the upper C-pillar trim.
7. Carefully pry the lower edge of the upper C-pillar trim away from the quarter inner panel far enough to disengage the lower spring clip retainers
that secure the trim to the slots in the quarter inner panel and remove the trim from the vehicle.
LOWER