Magnum V6-3.5L VIN V (2006)
stem.
3. Install valve seal/spring seat assembly over valve guides on all valve stem. Ensure that the garter spring is intact around the top of the rubber seal.
4. Place valve spring (color-coded end facing up) and valve retainer into position on spring seat.
5. Compress valve springs (4) with valve spring compressor C-3422-D and adapter 6526.
6. If valves (1) and/or seats are refaced, measure the installed height of springs. Measurements are taken from top of spring (4) seat to the bottom
surface of spring retainer. If height is greater than 38.75 mm (1.5256 inch), install a 0.762 mm (0.030 inch) spacer in head counterbore under the
valve spring seat to bring spring height back within specification.