Magnum V6-3.5L VIN V (2006)
29. Position the mode door actuator mounting bracket (6) onto the driver side of the air distribution housing (1).
30. Install the screws that secure the blend door actuator mounting bracket to the air distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
31. Position the blend door actuator (7) onto the air distribution housing. If necessary, rotate the actuator slightly to align the splines on the actuator
output shaft with those on the blend-air door linkage.
32. Install the screws (2) that secure the blend door and mode door actuators to the air distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
33. Install the air distribution housing onto the HVAC housing.
Air Inlet Housing
HOUSING-AIR INLET
DISASSEMBLY
1. Remove the air inlet housing (1) from the HVAC housing and place it on a workbench.
2. Remove the three screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.
3. Remove the recirculation-air door (4) from the air inlet housing.
ASSEMBLY
1. Position the recirculation-air door (4) into the air inlet housing (1).
CAUTION: Make sure that the recirculation-air door pivot shaft is properly seated in the pivot seats located on the air inlet housing.
2. Install the recirculation door actuator (3) onto the air inlet housing. If necessary, rotate the actuator slightly to align the splines on the actuator
output shaft with those on the recirculation door pivot shaft.
3. Install the three screws (2) that secure the recirculation door actuator to the air inlet housing. Tighten the screws to 2 N.m (17 in. lbs.).
4. Install the air inlet housing onto the HVAC housing.
HVAC Housing