Magnum V6-3.5L VIN V (2006)
Fuel Rail: Service and Repair
REMOVAL
WARNING: RELEASE FUEL SYSTEM PRESSURE BEFORE SERVICING FUEL RAIL. SERVICE VEHICLES IN WELL VENTILATED
AREAS AND AVOID IGNITION SOURCES. NEVER SMOKE WHILE SERVICING THE VEHICLE.
1. Release fuel system pressure.
2. Disconnect the negative battery cable.
3. Remove intake manifold plenum.
4. Cover intake manifold to prevent foreign material from entering engine.
5. Disconnect fuel supply tube quick connect fitting at the rear of the fuel rail.
6. Disconnect electrical connectors at fuel injectors. Refer to graphic. Push red colored slider away from injector (1). While pushing slider, depress
tab (2) and remove connector (3) from injector. The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for injector
position identification. If harness is not tagged, note wiring location before removal.
7. Remove mounting bolts on both sides of fuel rail.
8. Lift fuel rail straight up off of cylinder head.
9. Remove retaining clips from fuel injectors at fuel rail.
10. Remove fuel injector from fuel rail.