Magnum V6-3.5L VIN V (2006)
CAUTION: Always apply the bead of adhesive to the windshield. Always install the windshield within 5 minutes after applying the
adhesive.
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
17. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive (1) with a triangular nozzle approximately 6 mm (0.230 in.) from the edge of the
glass (2) starting at the bottom center of the windshield.
18. Run the end of the adhesive bead (1) on the windshield (2) parallel to the start of the bead and smooth the ends flush.
19. Using an assistant, position the windshield (2) over the windshield opening.
20. Using the grease pencil marks or tape as reference points, align the windshield to the opening.
21. Carefully lower the windshield onto the windshield fence. Guide the windshield and the rubber seal at the top the windshield into its proper