Magnum V6-3.5L VIN V (2006)
Headlamp Washer Hose: Service and Repair
HEADLAMP WASHER HOSE
REMOVAL
The headlamp washer hose (2) is a special high pressure hose with specific fittings (3), and must be replaced as a unit.
1. Disconnect and isolate the battery negative cable.
2. Loosen up the fascia (1) on the side of the vehicle in which hose needs replacing.
3. When disconnecting hose (2) , press down firmly on latch at headlamp washer pump motor and washer assembly (3) and pull apart.
INSTALLATION
The headlamp washer hose is a special high pressure hose with specific fittings, and must be replaced as a unit.
1. Install the new high pressure headlamp washer hose (2) assembly. Push fitting (3) on until a snap is heard.
2. Install the fascia.
3. Connect the battery negative cable.
