Magnum V8-5.7L (2008)
Steering Shaft: Service and Repair
Intermediate Shaft - Removal
REMOVAL
NOTE: This procedure applies to RHD vehicles only. The intermediate shaft (Z-coupling) on the LHD column is not serviceable.
1. Fully extend or pull out adjustable steering column (where applicable).
2. Position the front wheels straight-ahead. Center the steering wheel and lock it in place with a steering wheel holder.
3. Raise and support the vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
4. Remove the pinch bolt (3) connecting the intermediate shaft (1) to the steering coupling shaft (2).
5. Separate the intermediate shaft (1) from the steering coupling (2).
6. Lower the vehicle.
7. Remove the two retaining nuts (3) securing the intermediate shaft to the dash panel.
8. Loosen the shaft seal at the dash panel.