Magnum V8-5.7L VIN 2 (2007)
The owner's name, address and phone number are listed if known. Completed
vehicles are removed from GRS within several days of repair claim submission.
To use this system, click on the "Service" tab and then click on "Global Recall System." Your dealer's VIN list for each recall displayed can be sorted
by: those vehicles that were unsold at recall launch, those with a phone number, city, zip code, or VIN sequence.
Dealers must perform this repair on all unsold vehicles before retail delivery.
Dealers should also use the VIN list to follow up with all owners to schedule appointments for this repair.
Recall VIN lists may contain confidential, restricted owner name and address information that was obtained from the Department of Motor Vehicles of
various states. Use of this information is permitted for this recall only and is strictly prohibited from all other use.
Additional Information
If you have any questions or need assistance in completing this action, please contact your Service and Parts District Manager.
Customer Services Field Operations
DaimlerChrysler Corporation
Service Procedure
NOTE:
Reprogramming of the ABS Control Module can be performed using the StarSCAN scan tool or the StarMOBILE scan tool.
A.
Reprogram the ABS Control Module Using StarSCAN
NOTE:
The StarSCAN tool must be at version 7.03 or higher before this
procedure can be performed. The software release level is visible in the blue header at the top of the StarSCAN screen.
1.
Open the hood and install a battery charger. Verify that the charging rate provides approximately 13.5 volts.
2.
Use the following procedure to determine the ABS Control Module software part number:
a.
Connect the StarSCAN to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN"
position.
b.
Power ON the StarSCAN.
c.
From the StarSCAN Home Screen, select "ECU View".
d.
From the StarSCAN ECU View Screen, select "ABS" from the list of modules.
e.
Select "More Options" and then select "ECU Flash".
f.
Record the part number displayed at the top of the "Flash ABS" screen for later reference.
3.
Connect the CH9410 ethernet cable to the StarSCAN and the dealer's network drop.
4.
Select "Browse for New File" and follow the on screen instructions.
5.
Highlight the calibration and then select "Download to Scantool".
6.
Select "Close" after the download is complete, disconnect the ethernet cable from the scan tool and then select "Back".
7.
Highlight the listed calibration.
8.
Select "Update Controller" and follow the screen instructions.
9.
When the ABS control module update is complete, select "OK".
10.
Verify the part number (resident flash file) at the top of the screen has updated to the new part number.
11.
After completing the ABS control module reprogramming, clear all Diagnostic Trouble Codes (DTC's) using the following procedure:
