Magnum V8-5.7L VIN 2 (2007)
After a frontal impact where an airbag has been deployed due to a collision, the following MUST be replaced:
-
Front Seat Belt and Retractor (driver and passenger) with integral Tensioners.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
All other seat belts should be closely inspected for cuts, tears, fraying, or damage in any way following any frontal impact or airbag deployment. The
other seat belts are to be replaced when visible damage is incurred. Inspect the Lower Anchors and Tether for Children (LATCH) child restraint anchors
for damage after an impact event and replace as needed.
CLEAN UP PROCEDURE
Roll or fold the airbag towards its mounting point (i.e. instrument panel, steering wheel, knee blocker, curtain, or seat back). Then tape the ripped cover
over the deployed airbag if applicable.
Use a vacuum cleaner to remove any residual powder from the vehicle interior. Work from the outside in to avoid kneeling or sitting in a contaminated
area. Vacuum the heater and A/C outlets as well. If the heater or air conditioner was in RECIRC mode at time of airbag deployment, operate blower
motor on low speed and vacuum powder residue expelled from the heater and A/C outlets. Multiple vacuum cleaning may be necessary to decontaminate
the interior of the vehicle.
