Magnum V8-5.7L VIN H (2005)
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Raise and support vehicle.
4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
5. Remove banjo bolt (3) connecting flexible brake hose (1) to caliper (4). There are two sealing washers (2) (one each side of hose fitting) that will
come off when bolt is removed. Discard these washers; install NEW washers on installation.