dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - Cold Start Idle Cycling/Radiator Steam|Page 3234 > < Engine Controls - Poor A/C Performance|Page 3229
Page 1
background image

PROM - Programmable Read Only Memory: Customer Interest
Engine Controls - Cold Start Idle Cycling/Radiator Steam

NUMBER: 18-044-04

GROUP: Vehicle Performance

DATE: December 8, 2004

THE StarSCAN FLASH FILES FOR THIS BULLETIN ARE AVAILABLE VIA THE INTERNET.

SUBJECT:
Cold Start Idle Cycling Or Radiator Steaming At Idle

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software and replacing the MAP sensor.

MODELS:

2005

(LX)

Chrysler 300/Magnum

NOTE:

This bulletin applies to vehicles equipped with a 5.7L engine (sales code EZB) and domestic market emissions (sales code NAS) that were built on or
before December 1, 2004 (MDH 1201XX).

SYMPTOM/CONDITION:

The vehicle may experience one or both of the following conditions:

^

Cold start idle cycling after a minimum eight hour soak. This condition will occur in ambient temperature between 6.6° C (20° F) and 21.1° C (70°
F). The idle cycling will begin right after start-up and can last as long as one and a half minutes (1.5 minutes).

^

Radiator steaming while vehicle is idling (not moving).

PARTS REQUIRED:

NOTE:

When replacing the MAP sensor first inspect the four digit build date on the side of the replacement MAP sensor. If the build date is 2944 or less a
new MAP sensor must be ordered. The first three characters are the day of the year, the fourth character is the year, ie. 2944 is the 294th day of 2004.

SPECIAL TOOLS/EQUIPMENT REQUIRED:

REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:

Engine Controls - Cold Start Idle Cycling/Radiator Steam|Page 3234 > < Engine Controls - Poor A/C Performance|Page 3229