Magnum V8-5.7L VIN H (2005)
Headlamp Washer Hose: Service and Repair
REMOVAL
The headlamp washer hose (2) is a special high pressure hose with specific fittings (3), and must be replaced as a unit.
1. Disconnect and isolate the battery negative cable.
2. Loosen up the fascia (1) on the side of the vehicle in which hose needs replacing.
3. When disconnecting hose (2), press down firmly on latch at headlamp washer pump motor and washer assembly (3) and pull apart.
INSTALLATION
The headlamp washer hose is a special high pressure hose with specific fittings, and must be replaced as a unit.
1. Install the new high pressure headlamp washer hose (2) assembly. Push fitting (3) on until a snap is heard.
2. Install the fascia.
3. Connect the battery negative cable.