Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (usually applied to driver's side B-pillar). Make
sure original style valve stem cap is securely installed to keep moisture out of sensor.
7. Install tire and wheel assembly (1) on vehicle. Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
8. Lower vehicle.
9. Drive vehicle for a minimum of 10 minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time the system will learn
the new sensor ID code and will clear any DTC's automatically.
NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.
