Magnum SRT-8 V8-6.1L VIN 3 (2006)
8. Remove the SKREEM mounting screw (1) on the ignition lock assembly and separate the SKREEM from the ignition lock assembly.
NOTE:
-
After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the directions
on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during this operation. There is
no need to program the fob of the key for RKE functionality once the transponder key is programmed to the new SKREEM/WCM.
-
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order:
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Program all ignition/transponder keys to the new SKREEM/WCM.
INSTALLATION
NOTE:
-
After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the directions on
the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during this operation. There is no
need to program the fob of the key for RKE functionality once the transponder key is programmed to the new SKREEM/WCM.
-
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order:
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Program all ignition/transponder keys to the new SKREEM/WCM.
1. Position the SKREEM on the ignition lock housing and install the retaining screw (1).
