dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Parking Assist Control Module|Diagrams|Page 31 > < Parking Assist Control Module|Diagrams|Page 29
Page 2
background image

The display contains two sets of yellow and red Light Emitting Diode's (LED's) that the driver can see as they look over their shoulder while backing up.
Each side of the vehicle has its own warning LED's. The system provides a visual warning by illuminating one or more yellow LED's as the vehicle gets
closer to the object. As the vehicle continues to approaches the object, one red LED is illuminated and the system emits a series of short beeps. The tone
will remain constant and both red LED's are illuminated once the vehicle is within 12 inches (30.5 cm) of the object.

The system can be turned ON or OFF through the Electronic Vehicle Information Center (EVIC) when the vehicle is in PARK. If the park assist system
is turned OFF, a single chime will sound and the EVIC will display the following message "REAR PARK ASSIST OFF", when the vehicle is in reverse.

-

Ensure that the rear bumper is free of dirt and debris to keep the system operating properly.

-

Jackhammers, large trucks, and other vibrations could affect the performance of the system.

-

Ensure that the parking brake is not applied.

If "Service Park Assist System" appears in the EVIC after making sure the rear bumper is clean, proceed to diagnose the system using a scan tool and the
appropriate diagnostic information.

To diagnose the Park Assist Module, use a scan tool and the appropriate body diagnostic information.

Parking Assist Control Module|Diagrams|Page 31 > < Parking Assist Control Module|Diagrams|Page 29