Mini Ram Van L4-134 2.2L SOHC VIN C 2-BBL (1987)
C.
In-Tank Fuel Gauge/Pump Unit Assembly Installation
1.
Refer to the service manual procedure for removing fuel tank sending unit.
2.
Install seal, PN 6031475, on the new gauge/pump kit, PN 4075479* (15 gallon tank) or PN 4075480* (20 gallon tank). Using extreme
caution to protect the float and gauge assembly, install new gauge/pump unit in the fuel tank.
D.
Body Wiring Harness PM 4331724
1.
Install the mold of body harness, PN 4331724, onto the stud of the fuel tank unit.
FIGURE 3-A
2.
Insert the "basket handle" type clip into the existing ring clip on rear crossmember. Route the harness along the rear crossmember to the
left frame rail. Secure the harness using two tie wraps, PN 6015756 (Figure 3-A).
FIGURE 3-B - BODY WIRING
3.
Route the body harness, PN 4331724, along the existing brake lines on the left frame rail, working toward the engine compartment. Secure
the harness with eight tie wraps, PN 6015756, locating each tie wrap near the existing brake line clips (Figure 3-B).
