Monaco V6-182 3.0L SOHC (1990)
Extension Housing: Service and Repair
Long Output Shaft Replacement
1. Raise and support vehicle.
2. Remove differential drain plug, and drain lubricant.
3. Using a suitable punch, remove roll pin attaching driveshaft to output shaft.
4. Using a suitable screwdriver, remove output shaft dust cover.
5. Using seal removal tool No. 6159 and bolt from puller tool No. 6149 or equivalents, remove outer seal.
6. Using snap ring pliers, remove output shaft retaining ring. Remove output shaft and bearing from transaxle case.
7. Using a screwdriver, remove inner seal from case. Do not damage seal bore with screwdriver when removing seal.
8. Using seal installer tool No. 6154 or equivalent and a driver handle, install new inner seal.
9. Ensure output shaft bearing is packed full of suitable grease prior to shaft installation. Install output shaft and bearing, then the retaining ring.
10. Using seal installer tool No. 6152 or equivalent, install outer seal.
11. Using compressor tool No. 6156 or equivalent and a driver handle, install dust cover.
12. Install differential drain plug and torque to 18 lb-ft. Fill differential with synthetic type, 75W-140 hypoid gear lubricant. Add lubricant until it
flows from fill hole, then install fill plug and torque to 37 lb-ft.
13. Attach driveshaft to output shaft. Using suitable punch, install driveshaft roll pin.
14. Install underbody splash shield, then lower vehicle.
