Neon L4-2.0L SOHC (1995)
Seat Back: Customer Interest
Seat Back Release Knob - Comes Loose
NO: 23-67-95
GROUP: Body
DATE: Nov. 3, 1995
SUBJECT:
Seat Back Release Knob Comes Loose
MODELS:
1995-1996 (PL) Neon
NOTE:
THIS BULLETIN APPLIES TO 2 DOOR VEHICLES BUILT PRIOR TO 10-12-95 (MDH 10-12-XX).
SYMPTOM/CONDITION:
Plastic release knob falls off or housing may be cracked on seat back release. Knob may pull off when seat back release is being used or may be kicked
off on entry/exit of rear seats.
PARTS REQUIRED:
2
4773524
Knob and Housing, Inertia Release
1
4467709
Bond All Gel, Mopar
REPAIR PROCEDURE:
This bulletin involves the replacement of the inertia release knob and housing with revised parts.
1.
If knob and housing are still attached to the lever, remove knob and housing by pulling straight out. The knob and housing should come loose by
hand.
2.
Apply the Mopar Bond All Gel (P/N 4467709) around the tip of the lever. Insure that the small pin on lever is covered with the bonding agent.
Figure 1
3.
Install the new knob and housing (P/N 4773524) immediately after applying the bond. Allow the repair to cure for one hour before use.
4.
Repeat the procedure for the other side.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
