Neon L4-2.0L SOHC (1995)
25. Slide down the pieces of heat shrink tubing to cover each splice.
Be careful to center each splice inside the tubing.
Heat the tubing to shrink and seal the splice.
Use the approved air heat gun only.
26. Tape the wire harness over splices up to 1 1/2 inches behind the back of the RFI filter module box.
Install the new RFI filter assembly to the shroud (one screw).
27. Reinstall the right radiator fan module (two screws).
Torque to 7.2 Nm (65 In. Lbs.)
28. Install the new connector to the right fan motor RFI fan filter module assembly.
Push in until the connector snaps into place.
Slide the red tab sideways to lock the connector into place.
29. Re-install the left radiator fan module (two screws).
Torque to 7.2 Nm (65 In. Lbs.)
Route the RFI output wiring to the left fan motor, and install the connector to the left fan motor.
Push in until the connector snaps into place.
30. Referring to instructions and following all warnings.
Install:
-
upper radiator mounts
-
battery tray
-
battery
-
battery thermo-guard
-
radiator-to battery strut
31. Re-connect the body ground cable and battery cables.
Torque body ground cable screw to 4.0 Nm (35 In. Lbs.) and battery terminals to 7.2 Nm (65 In. Lbs.).
Verify proper fan operation.
32. Reset all radio pre-sets recorded in step 1.