Neon L4-2.0L SOHC (1995)
Engine Mount: Service and Repair
FRONT
1. Support engine and transaxle with suitable floor jack.
2. Remove front engine mount through bolt from insulator and crossmember mounting bracket.
3. Remove mass damper, front mount nuts and insulator assembly.
4. Remove front mounting bracket
5. Reverse procedure for installtion and tighten fasteners in this order.
a. Tighten bolt 1 to 3 Nm (20 in. lbs.) and bolts 2,3 and 4 to 108 Nm (80 ft. lbs.).
b. Tighten bolts 5 and 1 to 54 Nm (40 ft. lbs.).
c. Tighten unsulator assembly nuts to 54 Nm (40 ft. lbs.).
d. Install mass damper and tighten tio 54 Nm (40 ft. lbs.).
e. tighten thru bolt to 54 Nm (40 ft. lbs.).
LEFT
1. Raise and support vehicle, then remove left front tire wheel assembly.
2. Remove power distribution center and place aside.
3. Support transaxle with suitable jack, then remove the insulator through bolt from mount.
4. Remove the transmission mount fasteners and remove mount.