Neon L4-2.0L SOHC (1995)
14. Install engine mount bracket.
15. Install Right engine mount.
16. Remove jack from under engine.
17. Install crankshaft damper using M12-1.75 150 mm bolt, washer, thrust bearing and nut from Special Tool 6792. Install crankshaft damper bolt an
tighten to 142 Nm (105 ft. lbs.).
18. Install accessory drive belts. Refer to Cooling System and Accessory Drive for procedure.
19. Raise vehicle on hoist and install right inner splash shield.
20. Perform relearn camshaft and crankshaft alignment procedure in Engine Miscellaneous of the DRB Scan Tool.
