Neon L4-2.0L SOHC (1995)
Impact Sensor: Service and Repair
Right Impact Sensor
Fig. 7 Remove Or Install Battery Cable
WARNING: Before beginning any airbag system component removal or installation procedures, disconnect and isolate the battery negative
(ground) cable. This will disable the airbag system. Failure to do this could result in accidental airbag deployment and possible personal injury.
1. Remove battery negative cable and battery positive cable in this order.
2. Remove radiator fan module.
3. Drain and remove radiator.
Fig. 10 Impact Sensor Location
4. Remove three nuts holding sensor to stud plate on the closure panel.
5. Remove sensor and disconnect impact sensor electrical connector.
Fig. 11 Impact Sensor