Neon L4-2.0L SOHC (1995)
7. Remove the battery positive cable nut and remove the battery positive and generator output wire from the starter.
8. Disconnect push-on solenoid connector.
9. Position the starter vertically such that the pinion end faces downward.
10. Remove the starter through the bottom of the vehicle. Move a side A/C plumbing as necessary.
INSTALLATION
1. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.
2. Connect the battery positive and generator output wire to the starter solenoid post.
CAUTION: It is critical that the generator output terminal be connected to the battery positive terminal of the starter solenoid, for proper
operation of the charging and cranking systems.
3. Connect the push-on solenoid connector.
4. Set starter face into transmission housing. Support starter in pilot and start the top bolt.
5. Attach ground cable to lower mounting bolt and start bolt.
6. Tighten both mounting bolts to 30 Nm (40 ft lb) torque and assuring proper starter alignment.
7. Lower vehicle and connect battery cables.