Neon L4-2.0L SOHC (1995)
Window Regulator: Service and Repair
2 Door Models
NOTE: Power and manual door glass regulators are serviced using the same procedures. For power window motor service procedures, refer to Power
Window Motor/Service and Repair.
REMOVAL
1. Remove door trim panel and water shield. refer to Door Panel/Service and Repair.
2. Disconnect wire connector to power window motor, if so equipped.
Regulator Lift Channel
3. Remove nuts holding regulator lift channel to door glass.
4. Secure door glass in upward position.
5. Mark position of rear bolt of roller channel to inner door panel to aid in installation.
6. Remove bolt holding rear of roller channel to door panel.
7. Loosen bolt holding front of roller channel to door panel.
Roller Channel
8. Separate roller channel from door panel.
9. Loosen bolts holding window regulator to inner door panel.
10. Separate bolt heads from key-hole slots in inner door panel.