Neon R/T L4-2.0L VIN F HO (2001)
vehicle.
INSTALLATION
NOTE: Before proceeding with this procedure, Refer to Service Precautions.
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an open
circuit. Be sure that cables are installed, routed, and clipped properly.
1. Install the Wheel Speed Sensor (WSS) head into the disc brake adapter.
2. Install the WSS mounting bolt. Tighten the mounting bolt to a torque of 12 Nm (105 inch lbs.).
3. Install the WSS cable routing bracket on the rear strut.
4. Install WSS cable into the routing clips on the rear brake hose and brake tube.
5. Connect the WSS cable connector into vehicle wiring harness. Install the clip attaching the WSS cable connector to vehicle's body.
6. Lower the vehicle.
7. Road test the vehicle to ensure proper operation of the base brakes and Antilock Brake System (ABS).
