Nitro 2WD V6-4.0L (2007)
Parking Assist Control Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Partially remove the trim from the right quarter inner panel to access the park assist module (2), which is located above and behind the right rear
wheel house, forward of the D-pillar.
3. Disconnect the two body wire harness connectors (4) from the park assist module connector receptacles.
4. Remove the three plastic push-in fasteners (3) that secure the module to the right quarter inner panel (1).
5. Remove the module from the right quarter inner panel.