Nitro 2WD V6-4.0L (2007)
Seat Occupant Classification Module - Air Bag: Description and Operation
Description
DESCRIPTION
The Occupant Classification Module (OCM) (1) is secured with two screws to a stamped metal bracket on the inboard passenger side front seat riser
beneath the seat cushion. Concealed within a hollow in the center of the molded plastic OCM housing is a microprocessor and the other electronic
circuitry of the module. The module housing is sealed to enclose and protect the internal electronic circuitry.
Four mounting tabs (2) and two connector receptacles (3) are integral to the OCM housing. The two mounting tabs designed to accept self tapping
screws are used to secure the module to the mounting bracket, while the remaining two mounting tabs are unused in this application. The connector
receptacles contain terminal pins that connect the OCM to the vehicle electrical system through dedicated take outs and connectors of the passenger side
front seat wire harness.
The OCM and all of the other components of the Occupant Classification System (OCS) including the passenger side front seat, the seat weight sensors,
and the seat adjusters, cushion, back, frame, foam, springs, and wiring harness are a factory-calibrated and assembled unit. Any time any one of these
components is removed or replaced for any reason, the OCM must be re-calibrated using a diagnostic scan tool, the Occupant Classification Seat Weight
special tool, and the Occupant Classification System Verification Test. Refer to the appropriate diagnostic procedures.
The OCM cannot be adjusted or repaired and, if damaged or ineffective, it must be replaced. The OCM software is flash programmable. A
non-calibrated OCM is available for separate service replacement.
