Nitro 2WD V6-4.0L (2007)
NOTE: Ignition module must be installed prior to lock housing installation on column. Otherwise, the tilt lever will obstruct installation of
ignition switch.
1. Ensure the ignition module is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
2. Align the ignition module with the pin (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the module,
snapping it into place over the retaining tabs.
3. Install the ignition module (2) mounting screw (1). Tighten the screw to 2 Nm (18 in. lbs.).
NOTE: Ignition module needs to be installed on lock cylinder housing before housing installation to clear tilt lever.
4. Position the lock cylinder housing in the RUN position.
5. Align the lock cylinder housing (2) with the steering column.
