Omni L4-135 2.2L SOHC (1984)
FIGURE 1B
B.
Engine Compartment Wiring PN 4304992
1981-1982 & 1985-1987 Models Only (1983-1984 models have this wire built into original wire harness, therefore, 1983-1984 models proceed
to Section C)
1.
Route engine compartment overlay harness, PN 4304992, along the headlamp-to-dash engine compartment wiring harness across the cowl.
Loop and tape excess wire near ignition coil. Secure, using five tie wraps as shown in Figure 1-H.
2.
Install the eyelet terminal of the overlay harness, PN 4304992, to the NEGATIVE terminal of the ignition coil as shown in Figure 1-J.
3.
Install the blade terminal of the overlay harness, PN 4304992, into engine side bulkhead connector as shown in Figure 1-K and as follows: