RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
11. Remove the bolts holding the timing cover to engine block (Fig. 98).
12. Remove the timing cover.
INSTALLATION
CAUTION: Do not use oil based liquids to clean timing cover or block surfaces. Use only rubbing alcohol, along with plastic or wooden scrapers.
Use no wire brushes or abrasive wheels or metal scrapers, or damage to surfaces could result.
1. Clean timing chain cover and block surface using rubbing alcohol.
CAUTION: The 3.7L uses a special anerobic sealer instead of a gasket to seal the timing cover to the engine block, from the factory. For service
repairs, Mopar Engine RTV must be used as a substitute.
2. Inspect the water passage O-rings for any damage, and replace as necessary.
3. Apply Mopar Engine RTV sealer to front cover (Fig. 99).
4. Install cover. Tighten fasteners in sequence as shown in to 54 Nm (40 ft. lbs.) (Fig. 100).
5. Install crankshaft damper (Refer to ENGINE / ENGINE BLOCK / VIBRATION DAMPER INSTALLATION).
