RAM 1500 Truck 2WD V8-4.7L VIN N (2002)
Fig. 3 Remove/Install Generator - 3.7/4.7L
6. Remove 1 rear vertical generator mounting bolt (Fig. 3).
7. Remove 2 front horizontal generator mounting bolts (Fig. 3).
8. Remove generator from vehicle.
INSTALLATION
1. Position generator to engine and install 2 horizontal bolts and 1 vertical bolt.
2. Tighten all 3 bolts as follows:
-
Generator Vertical Mounting Bolt ........................................................................................................................................... 55 Nm (40 ft. lbs.)
-
Generator (long) Horizontal Mounting Bolt ............................................................................................................................ 55 Nm (40 ft. lbs.)
-
Generator (short) Horizontal Mounting Bolt ........................................................................................................................... 74 Nm (55 ft. lbs.)
3. Snap field wire connector into rear of generator.
4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut. Refer to Torque Specifications.
CAUTION:
-
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
-
When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction
if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment.
5. Install generator drive belt.
6. Install negative battery cable to battery.
