RAM 1500 Truck 2WD V8-5.2L VIN Y (1997)
GENERAL INFORMATION
The tensioner is equipped with an indexing arrow on back of tensioner and an indexing mark on tensioner housing.
New Belt
If a new belt is being installed, arrow must be within approximately 3 mm (1/8 inch) of indexing mark (point B). Belt is considered new if it has
been used 15 minutes or less. If this specification cannot be met, check for:
^
The wrong belt being installed (incorrect length/width)
^
Worn bearings on an engine accessory (A/C compressor, power steering pump, water pump, idler pulley or generator)
^
A pulley on an engine accessory being loose
^
Misalignment of an engine accessory
^
Belt incorrectly routed.
Used Belt
A used belt should be replaced if tensioner indexing arrow has moved to point A. Tensioner travel stops at point A.