RAM 1500 Truck 4WD V8-4.7L (2008)
2. Install the screws (1) that secure the blend door actuator (2) to the HVAC housing (3). Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the blend door actuator.
4. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation .
5. Reconnect the negative battery cable.
DUAL ZONE PASSENGER SIDE
6. Install the blend door actuator and bracket assembly (2) onto the top of the HVAC housing (3).
7. Install the screws (1) that secure the blend door actuator and bracket assembly to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).
8. Connect the HVAC wire harness connector (4) to the blend door actuator.
NOTE: Align the guide pin on the blend door lever with the guides on the blend door linkage during installation of the blend door lever.
9. Install the blend door lever (1) onto the blend door actuator output shaft (2) and the blend door linkage (3).
