RAM 1500 Truck 4WD V8-4.7L (2008)
Link/Coil - Return Hose - Gear To Cooler
RETURN HOSE - GEAR TO COOLER
1. Install the return hose to the vehicle.
2. Reconnect the return hose at the cooler.
3. Reconnect the return hose (2) at the gear. Tighten the hose to 51 Nm (38 ft. lbs.).
4. Reattach the hose to the routing clip at the fan shroud.
5. Remove the support and lower the vehicle.
6. Refill the power steering system. See: Power Steering Bleeding/Service and Repair
Link/Coil - Pressure Hose
PRESSURE HOSE
NOTE: Be sure to align the pressure hose so it does not contact the fan shroud or the frame rail.
1. Install the pressure hose to the vehicle.
2. Reconnect the pressure hose (2) at the gear (4). Tighten the hose to 32 Nm (23 ft. lbs.).
3. Reconnect the pressure hose at the pump. Tighten the hose to 36 Nm (27 ft. lbs.).
4. Remove the support and lower the vehicle.
5. Refill the power steering system. See: Power Steering Bleeding/Service and Repair
Link/Coil - Return Hose - Reservoir To Cooler
RETURN HOSE - RESERVOIR TO COOLER
1. Install the return hose to the vehicle.
2. Reconnect the return hose at the cooler.
3. Reattach the hose to the routing clip at the fan shroud.
4. Remove the support and lower the vehicle.
5. Reconnect the return hose at the reservoir.
6. Refill the power steering system. See: Power Steering Bleeding/Service and Repair