RAM 1500 Truck 4WD V8-4.7L (2008)
3.7L/4.7L/5.7L Engine
3.7L/4.7L/5.7L ENGINE
1. Position the transmission cooler tubes to the front of the radiator by sliding brackets into slots on radiator inlet tank.
2. Snap the transmission cooler tubes into the clips on the side of the radiator tank.
3. Install the transmission cooler attaching bolt. Tighten the bolt to 16 Nm (140 in. lbs.).
4. Inspect the quick connect fittings for debris and install the quick connect fitting on the cooler tube until an audible "click" is heard. Pull apart the
connection to verify proper installation and install the secondary latches See: Procedures .
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission.
Water-To-Oil Cooler
INSTALLATION - WATER-TO-OIL COOLER
