RAM 1500 Truck 4WD V8-4.7L (2008)
1. With vehicle in neutral, position vehicle on hoist.
2. Remove exhaust crossover pipe.
3. Mark a line across axle (3)/transfer case (2) companion flange and propeller shaft flange yokes for installation reference.
4. Remove axle/transfer case companion flange bolts.
5. Remove propeller shaft.
Front LD
INSTALLATION
1. Install propeller shaft with all reference marks (4) aligned.
2. Install with dust boot clamp at transfer case end.
3. Install new axle companion flange bolts and tighten to 115 Nm (85 ft. lbs.).
NOTE: Companion flange bolts incorporate a Loctite(R) patch, new bolts should be used. If bolts are not available, clean bolts and apply
Loctite(R) 242 to the threads.
4. Install skid plate, if equipped.
Front HD
INSTALLATION
