RAM 1500 Truck 4WD V8-4.7L (2008)
6. Disconnect the wiper motor electrical connector (Figure 1).
7. Remove the wiper motor linkage arm retaining nut from the wiper motor shaft (Figure 1)
8. Remove the wiper motor linkage arm from the motor shaft.
NOTE:
Do not disconnect the wiper motor linkage arm from the remaining wiper linkage.
9. Remove the three wiper motor retaining bolts (Figure 2).
10. Remove the wiper motor from the vehicle.
11. Transfer the rubber isolator from the old wiper motor onto the new wiper motor (Figure 2).
12. Discard the old wiper motor.
13. Place the new wiper motor into position.
14. Install the three wiper motor retaining bolts (Figure 2).
15. Tighten the upper wiper motor retaining bolts to 70 in. lbs. (8 N.m).