RAM 1500 Truck 4WD V8-4.7L VIN N (2003)
Wiper Relay: Service and Repair
Wiper High/Low Relay Replacement
WIPER HIGH/LOW RELAY
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.24 Integrated Power Module
2. Remove the cover from the Integrated Power Module (IPM).
3. Remove the wiper high/low relay by grasping it firmly and pulling it straight out from the receptacle in the IPM.
INSTALLATION
1. Position the wiper high/low relay to the proper receptacle in the Integrated Power Module (IPM).
2. Align the wiper high/low relay terminals with the terminal cavities in the IPM receptacle.
3. Push firmly and evenly on the top of the wiper high/low relay until the terminals are fully seated in the terminal cavities in the IPM receptacle.
4. Reinstall the cover onto the IPM.
5. Reconnect the battery negative cable.