RAM 1500 Truck 4WD V8-4.7L VIN N (2003)
Axle Bearing: Service and Repair
Front Axle - C205F
AXLE BEARINGS
REMOVAL
1. Remove half shaft from vehicle.
2. Remove skid plate, if equipped.
3. Clean axle seal area.
4. Remove axle shaft O-ring.
5. Remove axle shaft.
6. Remove axle shaft seal.
7. Install axle shaft bearing Remover C-4660-A in the bearing (Fig. 28). Then tighten the nut to spread the remover in the bearing.
8. Install the bearing remove cup, bearing and nut (Fig. 29). Then tighten the nut to draw the bearing out.
9. Inspect the axle shaft tube bore for roughness and burrs. Remove as necessary.
INSTALLATION
1. Wipe the axle shaft tube bore clean.
