RAM 1500 Truck 4WD V8-5.2L VIN Y (1997)
Power Lock Motor And Latch Remove/Install
7. Roll the door watershield away from the bottom of the inner door panel far enough to access the power lock motor.
8. Remove the three screws that secure the power lock motor and latch assembly to the door.
9. Disconnect the latch linkage rods.
10. Pull the power lock motor and latch out from the door far enough to unplug the wire harness connector.
11. Remove the power lock motor and latch assembly from the door.
12. Reverse the removal procedures to install. Tighten the power lock motor and latch screws to 10.5 N.m (95 in. lbs.).