RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Rear Door Window Regulator: Removal and Replacement
Window Regulator-Power
WINDOW REGULATOR-POWER
REMOVAL
1. Remove the inner belt molding, Refer to Weatherstrip.
2. Remove the waterdam, Refer to Rear Door Panel.
3. Remove the electric window switch from the door trim panel and connect it to the door wire harness.
4. Raise the door glass to the position shown.
5. Remove the two nuts (1) that secure the door glass (2) to the window regulator (3) through the speaker opening (5) and the sight window (4) and
disengage the door glass from the regulator.
6. Position the door glass to the full up position and secure the glass using a wooden wedge or an equivalent.
7. Lower the window regulator (2) and remove the two nuts that secure the regulator stabilizer to the door.
8. Remove the lower bolt (1) that secures the window regulator to the door and loosen the other two regulator bolts.
9. Slide the window regulator upward and disengage the two regulator bolts from the door.
10. Remove the window regulator through the opening in the door and disconnect the door wire harness (3).
INSTALLATION